Daily maintenance and maintenance of pipe cutters

1. Every working day must clean the dirt of the machine tool and guide rails, keep the bed clean, turn off the air source and power supply when leaving work, and empty the residual air in the machine tube.

2. If you leave the machine for a long time, turn off the power to prevent non-professionals from operating.

3. Pay attention to the presence of lubricant on the horizontal and longitudinal guide rails of the machine and the surface of the rack to keep it lubricated! 3. Weekly maintenance and maintenance:

1. The machine should be thoroughly cleaned every week, horizontal and vertical guide rails, drive gear racks are cleaned, and lubricating oil is added.

2. Check whether the horizontal and vertical rail cleaners work normally, and if not, replace them in time.

3. Check all the torches for looseness, clean the trash at the ignition gun, and keep the ignition normal.

4. If there is an automatic height adjustment device, check whether it is sensitive and whether to replace the probe.

5. Check if the plasma cutting tip and electrode are damaged, and if the cutting tip and electrode need to be replaced.