-
How to hot melt ppr tube
31 Oct 2019Cutting First look at the direction of your pipe, there is the water supply and return pipe, and look at the diameter of the pipe is generally six inches and one inch of the tube, then look at how much heating is 60 or 50 is the height After confirmi...
-
Automatic hot melt welding machine control box structure
26 Oct 2019PE is polyethylene, the material can generally melt in the temperature range between 190 ° C - 240 ° C, usually in the gas pipeline construction in the fused connection and hot melt butt joints need to use PE automatic hot melt welding machine. ...
-
High power butt welder parameters and application scenarios
17 Oct 2019Un-25, 100, 150 type butt welder is easy to operate. Lever pressure is suitable for welding of high and low carbon steel alloy steel non-ferrous metal rods, plates, rings, tubes and other profiles. The corresponding series and corresponding adjustmen...
-
Hot melt butt welder use and inspection content
09 Oct 2019The hot melt butt welder is a special welding equipment that applies hot melt butt joint technology to weld thermoplastic pipe fittings. The welding frame of the hot melt butt welder is separate from the operating system. The whole machine is compose...
-
The entire butt cooling process of the hot melt butt welder
29 Sep 2019When the hot melt butt welder is operated, reduce the drag resistance as much as possible, and clamp the pipe or pipe socket end on the butt welder; check whether the butt welder matches the pipe diameter and the regular docking cycle; move the movab...
-
Solution to problems in the welding process of pipe hot melt welding machine
23 Sep 2019In the welding process of the pipe hot-melt welder, if the temperature is too low, after the end of the hot melt, it can be seen that the stigma is small, the components are loose, and even they can be separated. If you look at the thermostat at this...
-
Electrofusion welding machine for hot melt butt welding
16 Sep 2019The connection interface of the electric fusion welding machine for hot-melt butting is flat. The method is to heat the two identical connection interfaces to the viscous flow state with the hot plate, remove the hot plate, and then apply a certain p...
-
General method for hot melt welding
06 Sep 20191. Welding method: Ultrasonic vibration transmits ultrasonic waves to the weldment along with the welding head. Due to the large acoustic resistance at the two weldments, local high temperature is generated, and the weldment interface is melted. Unde...
